[. . . ] Should the appliance power supply cable need to be replaced, this must be carried out by our Service Centre. €¢ Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation. €¢ Do not pull the mains cable to disconnect the appliance. [. . . ] Press and hold function buttons (B) and (C) at the same time until the indicators of function buttons (A), (B) and (C) start to flash. €¢ The display shows the current setting of the acoustic signals. 1 Multitab Activate this option only when you use the combi detergent tablets. Make sure that the appliance is in setting mode, refer to ‘Setting and starting a programme'. Press and hold function buttons (D) and (E) at the same time until the multitab indicator comes on. If you stop to use the combi detergent tablets, before you start to use separately detergent, rinse aid and dishwasher salt, do these steps: 1. Make sure that the salt container and the rinse aid dispenser are full. Start the shortest programme with a rinsing phase, without detergent and without dishes. Make sure that the set level of the water softener agrees with the water hardness in your area. Contact your local water authority to know the water hardness in your area. Manual adjustment Turn the water hardness dial to the position 1 or 2. Make sure that the appli- ance is in setting mode, refer to ‘Setting and starting a programme’. Press and hold function buttons (B) and (C) at the same time until the indi- 56 www. €¢ The display shows the current setting of the water softener, e. Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. Make sure that the appliance is in setting mode, refer to ’Setting and starting a programme’. €¢ If the rinse aid indicator is on, fill the rinse aid dispenser. €¢ If you use the combi detergent tablets, activate the multitab option. Set and start the correct programme for the type of load and the degree of soil. If the programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. 2 Setting and starting a programme Setting mode The appliance must be in setting mode to accept some operations. [. . . ] 2 How to activate the rinse aid dispenser The activation of the rinse aid dispenser can occur only with the multitab option activated. Make sure that the appliance is in setting mode, refer to ‘Setting and starting a programme'. Press and hold function buttons (B) and (C) at the same time until the indicators of function buttons (A), (B) and (C) start to flash. Com • The display shows the current setting of the rinse aid dispenser. [. . . ]